Coriolis flow meters supplier today: When to use a volumetric flow meter or a mass flow meter? A volumetric flow meter is recommended when high accuracy is not required when measuring gas volumetric flow. However, when comparing results, a volume flow meter requires additional temperature and pressure compensation. Mass flow meters, on the other hand, measure flow rate independent of gas pressure and temperature. As a result, mass flow measurements are more reliable, accurate, and repeatable. See additional info on coriolis mass flow meter manufacturers.
The selection of gas turbine flowmeters is a difficult task for many people. In fact, as long as the relevant precautions are mastered, the selection of gas turbine flowmeters will become very simple. Fully understand the qualifications and performance of gas turbine flow meter suppliers. When purchasing gas turbine flowmeters, imported brands are basically familiar to everyone. However, when purchasing domestic brands, it is necessary to fully understand the qualifications and performance of suppliers. You can get a first-hand account of it by visiting it in person or by asking people who have used the brand before. It is recommended to use brands with high reputation in China, good user reputation and outstanding performance as much as possible.
Influence of humidity on measurement results when using vortex meter. The output of the vortex flowmeter is only proportional to the flow velocity of the fluid flowing through the measuring tube. When measuring wet saturated steam, the influence of water droplets on the output of the turbine flow meter is negligible, so it can be considered that the output of the turbine flow meter is entirely caused by the wet flow. Caused by the dry part of the steam. The density of the dry part, whether it is pressure compensation or temperature compensation, can be detected more accurately. The results of steam measurement are often used as the basis for economic settlement between the supply and demand sides. If the two parties agree to settle the fee according to the dry part of the steam and no charge for the condensed water, the impact of the phase change on the measurement is negligible and can be ignored.
The Insertion Density Meters are equiped with the microprocessors inside, so the sensor could complete the signal conditioning, calculation and diagnosis functions, and it does not need the remote eletronic devices for processing. Typical industries applied include the petrochemical industiry, electricity power industry, wine industry, food industry, pharmaceutical industry, and mineral processing (such as, clay, carbonate, silicate, etc. ) For sepecific applications, the Insertion Density Meters are largely used in the interface detection of the multi-product production lines, density detection of the mixed liquid, end monitoring of the reaction kettle, and the separator interface detection.
Fork density meter can measure the density, concentration, gravity, temperature, and accuracy of liquids without being affected by temperature, pressure, density, and viscosity. Applications of micro motion fork density meter: Pipeline interface inspection, slurry solids monitoring and corrosive acid concentration control; density and concentration monitoring that require rapid response. Continuously measure pipelines in real-time through pipelines and storage tanks to increase installation flexibility and choose from a variety of corrosion-resistant materials to measure the density and concentration of key chemicals. Supports protocols connected to DCS, PLC and flow computers. Pass Hazardous Area Approved Head-Mounted Transmitters extend the range of use, the transmitter supports local configuration and display. See additional information at https://www.bjssae.com/.
Sincerity, excellence in coriolis flow meter production with 33 years experience, Since 1987.Through continuous research, development and transformation, we have become the leader of the Coriolis Mass Flow Meters industries in China.Our products including coriolis mass flow meter,thermal mass flow meter,fork density meter and etc.We have 100+ workers and 5000+ factory,our customers from all over the world. We support OEM coriolis mass flow meter name plates.
In the flow calculator, the mass flow rate can be calculated according to the temperature and pressure of the superheated steam, but when the superheated steam is transported for a long distance, or due to improper insulation measures of the pipeline, the temperature will often drop due to heat loss. The superheated state enters the critical saturation state, and even part of the steam condenses and undergoes a phase change and turns into water droplets. At this time, it becomes wet saturated steam.